fea-nux

Skip to comment form »

1. mechanicaldesign said on September 15, 2009 at 3:37 am

   Good afternoon,

   I’m sorry because I dsiturb with an stupid questio : ANSYS11 can be installed on KDE4.3 ?

   Thank you in advance for your answare and support.

   Best regards.

2. sheldon said on September 15, 2009 at 8:11 am

   The desktop environment (e.g., Gnome or KDE or Xfce) shouldn’t matter.

   I have run ANSYS products fine on either Gnome or KDE in CentOS 4.7, for example.

3. mechanicaldesign said on September 15, 2009 at 10:57 pm

   Good morning,

   In Gnome works fine ANSYS11, both with workbench ?

   Thank you in advance for support.

   Best regards.

4. sheldon said on September 15, 2009 at 11:44 pm

   ANSYS Workbench 11.0 only works for the operating systems listed in the documentation. CentOS 4.7, which is essentially similar to RHEL 4, should work fine, whether you are using KDE (default) or Gnome.

   If you are having problems with ANSYS Workbench 11.0, I suggest you use the supported Linux distributions indicated in the ANSYS 11.0 Installation and Configuration Guide.

5. mechanicaldesign said on September 15, 2009 at 11:56 pm

   Good morning,

   I’m sorry because I disturb you again with my question, but in fact ANSYS11 work good on KDE (inclusiv workbench) comparison with Ubuntu9.04 (when workbench cannot be launched) ?

   Thank you in advance for your support.

   Best regards.

6. mechanicaldesign said on September 23, 2009 at 5:19 am

   Good afternoon,

   Why when I try to install Centos version 4.x, on my desktop dont apear the partition where I want to install it (for example on my desktop dont apear partion “swap” or “ext3” or other type of partion used on hardware), in comparison with other version of linux?

   Where is the problem ? All version of CentOS 4.x installed are dowmloaded in image form on DVD-iso.

   Best regards.

7. sheldon said on September 24, 2009 at 9:59 am

   You are asking general CentOS questions, not items specific to ANSYS usage.

   Consequently, our questions would be better posted on the CentOS forums:
   http://centos.org/modules/newbb/index.php?cat=3